Attach sewer hose normally OR continue to Step 2 if already attached.

*only required for initial set up – can be left installed for travel*  

Connect the smaller hose clamp to the RV sewer outlet pipe.  Position d-ring at the top  of the pipe. (12 o’clock position)  The hose clamp can be placed at any depth on the pipe as long as it does not interfere with the hose.  See photo below: 

Attach the hose clamp to the bracket by sliding it through the open notches at the bottom, if not already attached. For help, watch the instruction video below

Next, attach the Bracket Assembly (hose clamp with bracket) to the sewer clean out pipe at your campground with the bracket on the side furthest away from the RV.  The inside of the bend in the bracket should be facing towards the RV. (impact recommended but not required)

Lay material down underneath the hose.  Overlap it where necessary to achieve proper length.

Connect the tension cord with carabiner to the d-ring at the RV Outlet, then connect the cam end of the tension cord to the bracket on the sewer clean out pipe.  Keep this relatively loose and lay it next to the hose and on the inside of the vinyl.  Choose the lowest hole of the holes on either side for best performance.

Velcro the vinyl sleeve including the sewer hose and tension member.

Pull tightly on the cord near the cam and tighten until the hose is lifted off of the ground and properly supported. You may need to pull a little harder than you think at this step, but it should tighten relatively smoothly for most set ups.

Now sit back and relax! Your sewer hose is fully supported and you can store your hose cover with the hose when you’re ready to change sites.